As many as half of all embedded designs have an FPGA next to a microcontroller. The FPGA can be used to implement anything from glue logic, to custom IP, to accelerators for computationally intensive ...
Many microcontroller designs typically mix multiple interfacing methods. A microcontroller (µC) system can be viewed as a system that reads from inputs, performs processing and writes to outputs.
Sending data from a microcontroller to a PC usually requires some sort of serial connection, either through fiddly on-chip USB, FTDI chips, or expensive radio ICs. [Scott] didn’t want to deal with ...
USB interfaces are everywhere today, with low cost flash memory drives and all kinds of USB peripherals readily available. But these are very much focused on the PC market. Attempt to make use of ...
"When this chip is released, it will truly revolutionize the industry and provide the next generation of performance against which all other micro devices will be measured." That's how NEC's new ...
The new laser diode driver iC-HT permits microcontroller-based activation of laser diodes in CW mode. With this device laser diodes can be driven by either the optical output power (using APC), the ...
Voltage-to-current converters that feed grounded loads are common in industrial measurement and control applications. The conventional "textbook" circuit uses both positive and negative supply rails.
Grenoble, France – March 30, 2015 – Tiempo Secure, a semi-conductor specialist focusing on high-end secure products, introduces its dual interface secure microcontroller TESIC-SC built around its ...
As many as half of all embedded designs have an FPGA next to a microcontroller. The FPGA can be used to implement anything from glue logic, to custom IP, to accelerators for computationally intensive ...
Results that may be inaccessible to you are currently showing.
Hide inaccessible results