Modern milling machines look much the same as they did 30 years ago. However, they now must cut superalloys, titanium, and high-tensile steels to closer tolerances and at faster rates than before. To ...

Cat's PM-465 has simplified grade and slope control system that provides three operating menus. On-board electronics also regulate speed, steering and rotor drive, plus self-diagnostics. Milling ...

Now firmly established as road-building technologies, cold milling and the use of reclaimed asphalt pavement have placed the providers of milling machines in a good position at this time. "There's ...

Tangential milling may double or triple insert edge life while allowing for higher material-removal rates. TWO SHOPS HAVE FOUND THAT THEY can improve their rough-machining operations by adopting ...

The bulk of the milling machine market consists of half-lane machines weighing from 60,000 to 90,000 pounds and typically equipped with roughly 7-foot-wide cutting drums, which are powered by 600- to ...

It’s easy to assume that not much has changed with face mills for a while. There’s been so much attention on other milling processes over the last few years, and face mills, or shell mills, were ...